Homemade tone on tone bars of soap

#v15872

Make your own soap with tone on tone colours. Make a large bar of soap from 1300 g soap base following the step-by-step instructions. Cut it into 12 pieces, each approx. 2 cm wide. Remember to place your bar of soap in a soap dish, allowing it to dry out between each use.

Seleccione los productos para la idea

{{ optionsGroup.label }}

{{ getVariantsButtonText(option) }}
   
 
 
   
 
 
   
 
 
   
 
 
   
 
 
Precio total
{{ getFormattedBundlePrice() }}

{{ getRewardMessage() }}

Guide step %d
1   Weigh 650 g white soap base and 650 g transparent soap base. We recommend you use gloves because the soap base gets hot and because the lavender essential oil is very concentrated.
Guide step %d
2   You can melt the soap base either in a water bath or in a microwave when it is cut into 3 x 3 cm chunks. Begin by melting 250 g white soap base in the microwave at 80% power with 30 second intervals and stir between each interval to prevent heat damage. Add 4 cm pink soap dye paste, 1 cm purple soap dye paste and 9 drops of lavender essential oil. Stir well.
Guide step %d
3   Wash the mould and spray it with rubbing alcohol. Leave to dry.
Guide step %d
4   Lean the mould by 1 cm on one side. Pour in the coloured molten soap. Remove any air bubbles from the surface of each layer of molten soap by spraying with rubbing alcohol.
Guide step %d
5   Melt another 250 g white soap base cut into 3 x 3 cm chunks in the microwave with 30 second intervals. Stir between each interval to prevent heat damage. Add 2 cm pink soap dye paste, 0.5 cm purple soap dye paste and 9 drops of lavender essential oil. Stir well.
Guide step %d
6   Pour the next layer of molten soap into the mould when the surface of the first layer of molten soap is dry. Carefully pour the next layer of molten soap using a spoon for spreading it as shown in the photo.
Guide step %d
7   Melt 325 g transparent soap base cut into 3 x 3 cm chunks in the microwave with 30 second intervals. Stir between each interval to prevent heat damage. Add 1 cm pink soap dye paste, 0.5 cm purple soap dye paste and 9 drops of lavender essential oil. Stir well.
Guide step %d
8   Pour the next layer of molten soap into the mould when the surface of the second layer of molten soap is dry. Carefully pour the next layer of molten soap using a spoon for spreading the it.
Guide step %d
9   Melt 325 g transparent soap base and 150 g white soap base in two different containers. Cut the soap base into 3 x 3 cm chunks and melt in the microwave with 30 second intervals. Stir between each interval to prevent heat damage. Add 0.5 cm pink soap dye paste, 0.25 cm purple soap dye paste and 9 drops of lavender essential oil to the transparent soap base. Stir well. Do not add any soap dye paste to the white soap base, but add 4 drops of lavender essential oil and stir well.
Guide step %d
10   Place the mould flat on the table once the molten soap is dry. Now pour the molten transparent soap into the mould when it is approx. 50°C. Save a small amount to use for decoration later.
Guide step %d
11   Carefully pour 1/3 of the white molten soap into the transparent molten soap base in the mould. Use a wooden flower stick to slightly mix the colours to make a marbled effect. Both soap bases should be approx. 50°C. If the molten soap is too hot or too cold, the colours will become muddled together. Let the marbled layer set. Mix a small amount of purple soap dye paste with the next 1/3 of the white molten soap base and carefully pour into the mould using a wooden spoon.
Guide step %d
12   Leave this layer to set and finish with a plain layer of the remaining 1/3 of molten white soap base. Carefully pour it into the mould using a wooden spoon but only along one half of the length of the mould as shown in the photo.
Guide step %d
13   Sprinkle dried lavender onto the molten soap base whilst it is still soft, enabling you to slightly push the dried lavender into the surface. NB: if you are using dried flowers in the molten soap base, the colour may seep slightly into the soap which over time may turn slightly brown.
Guide step %d
14   You may heat up the last little bit of the transparent pink soap base. Use this to make decorative patterns on the surface.
Guide step %d
15   Cut slices of soap from the finished large bar of soap. Here is a cross section revealing the pattern.
También vete a explorar
Retroceder
estoy de compras como
Continuar como guest
Sus beneficios de iniciar sesión

✔ Tu lista de deseos personal

✔ Tu historial de pedidos

✔ Finalización rápida de tus pedidos
Sus beneficios de iniciar sesión

✔️ Tus precios especiales

✔️ Productos B2B especializados

✔️ El universo de marketing B2B
Sus beneficios de iniciar sesión

✔ Contenidos especiales para ti

✔ Tus precios especiales
Copyright © 2021-present Creativ Company | Rasmus Færchs Vej 23 | 7500 Holstebro | Dinamarca | Teléfono: 0045 96 10 1089 | export@cchobby.com