LED lights with lamp shades made from skeleton leaves

1   Use four skeleton leaves, a small 2.5 cm piece of design tape and a small piece of power tape for each bulb.

2   Carefully assemble the leaves around the wire just underneath the bulb.

3   Attach the design tape tightly, but carefully, once all four leaves are assembled.

4   Cut a small piece of power tape and attach this onto the end of the design tape. This is to make sure that the tape is attached properly. Remove the red foil from the power tape and tighten the end of the design tape around the wire.

Another variant   You may decorate the LED lights in different colours. In this photo each bulb is decorated with two gold skeleton leaves and matching design tape.