5576b61d76e69.jpg)
Necklaces with Pendants
#v12814
Colour in a design from shrink plastic sheets with a neon marker pen. Thread the pendant onto a piece of satin cord.
Cómo hacerlo Descarga nuestras guías paso a paso
1. Draw a design on the rough side of the shrink plastic sheet.
2. Cut out the design.
3. Colour in the design with a Stabilo Marker.
4. Make a hole in the design for hanging.
5. Put the design in the oven at 160°C until it has shrunk and unfolded again.
6. Cut a piece of satin cord for the necklace and attach fold-over cord ends onto each end of the satin cord.
7. Insert a round jump ring through the hole of the shrink plastic sheeet pendant and through both loops of the fold-over cord ends. Close the round jump ring.
8. Thread large plastic beads onto the doubled-over satin cord to hide the joint.
También vete a explorar
