A Leather Bracelet with Stone Beads on a Fishing Line Nylon Cord

1.   Cut a 80cm long piece of leather cord and double it over. Cut a 110cm long piece of fishing line nylon cord and tie it tightly around one end of the doubled-over leather cord, making a loop. There are now two equal length ends of fishing line nylon cord on either side of the doubled-over leather cord. The loop on the leather cord is to be used as the fastener (opening and closing the bracelet).

2.   Now pass each end of the fishing line nylon cord underneath each side of the leather cord. Thread each end of the fishing line nylon cord through the hole of a bead from opposite ends. Now pass the fishing line nylon cord over the leather cords ...

3.   ... and underneath the leather cords. Tighten – and continue the described process until the bracelet has reached the desired length.

4.   Thread the flower-shaped resin bead onto the bracelet in the same way as the stone beads.

5.   Tie a reef knot or two or three double knots on the back of the bracelet. (This is done by twisting one end twice or three times inside the loop before tightening).

6.   Tie the two leather cord ends together in a knot. Trim.