Braided bracelets

Step 1.   Double over the braided cord and put it through the hole of the pendant. Braid approx. 5-6cm.

Step 2.   Fasten the 2 middle cords on the back using a darning needle.

Step 3.   Cut off the ends and melt the last few mm.

Step 4.   Push down the melted end immediately.

Step 5.   Now braid from the other side of the pendant and fasten as before. Put the 2x2 ends so they are parallel and braid with a new cord. Fasten the ends and melt.

Step 6.   Tie knots on the last 4 ends. Melt the knots slightly.